Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| en:hardware:avr-can:exercise_1 [2010/04/05 09:58] – created mikk.leini | en:hardware:avr-can:exercise_1 [2020/07/20 09:00] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Exercises ====== | ====== Exercises ====== | ||
| - | ====Exercies | + | ====Exercise |
| - | For this exersise | + | For this exercise |
| (board 1) and a second CAN board (board 2). Board 2 is similar to board 1, | (board 1) and a second CAN board (board 2). Board 2 is similar to board 1, | ||
| except that it is not programmed yet. You will also use the USB-CAN-Terminal | except that it is not programmed yet. You will also use the USB-CAN-Terminal | ||
| Line 16: | Line 16: | ||
| an alternative set-up. CAN-messages could also be displayed on a LCD. | an alternative set-up. CAN-messages could also be displayed on a LCD. | ||
| Important: Follow the instructions given in " | Important: Follow the instructions given in " | ||
| - | sources ! Use the jumper TERM on board 2 to enable the terminating resistance | + | sources! Use the jumper TERM on board 2 to enable the terminating resistance! Use the jumpers JP1 on board 1 and board 2 to power board 2 over the CAN |
| - | ! Use the jumpers JP1 on board 1 and board 2 to power board 2 over the CAN | + | bus! |
| - | bus ! | + | |
| Assignment: Use the provided 10-way ribbon cable to connect the two boards. | Assignment: Use the provided 10-way ribbon cable to connect the two boards. | ||
| Make sure to position the connector in the right way, as indicated by a " | Make sure to position the connector in the right way, as indicated by a " | ||
