ARM-CAN kit setup

1. Install Keil uVision Evaluation version
   

Located in Software/mdk410.exe

1. Install StellarisWare
   

Located in Software/SW-LM3S-5570.exe
It is necessary to install it to the “C:\StellarisWare” folder otherwise example project files should be re-configured.

1. Copy examples to your computer
   

Copy Examples folder to any place in your harddrive. Please note that after modifing project files uVision saves file paths as absolute so moving the folder later can cause trouble.

1. Connect the programmer to your computer
   

Stellaris Evalution Board clone should be found. Install the device drivers located in Software/Luminary_FTDI_Driver folder.

1. Connect the programmer with 20 wire ribbon cable to target board and power the board

either through the USB port or external 5V power supply

1. Try any example project file (.uvproj extension) with Keil uVision
   

You can use uVision to compile and download project code to ARM device. Please note that uVision does not reset the device after programming so it is required to press the reset button (left one) on board after downloading the code.