Differences

This shows you the differences between two versions of the page.

--- en:hardware:arm-can:setup [2010/05/26 16:13] – created mikk.leini
+++ en:hardware:arm-can:setup [2020/07/20 09:00] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-====== ARM-CAN kit setup ======
+====== Kit Setup ======
+===== Connecting Modules =====
+[{{  :images:hardware:arm-can:connecting:controller_programmer.jpg?250|Connecting Programmer to Controller}}]
+To use the programmer connect it as shown in the picture. Currently there are two versions of programmers - one which plugs right on top of controller boar, and another one with 20-pin ribbon cable. Both of these versions have a USB receptable on the right side.
+[{{  :images:hardware:arm-can:connecting:controller_userinterface.jpg?250|Connecting User-interface to Controller}}]
+The connection of the user-interface is done through a COMM connector with ribbon cable as shown in the picture.
+~~CL~~
+===== Installing Software =====
+  - **Install Keil uVision Evaluation version** \\ It is named //Software/mdk410.exe// on CD. The same evaluation version is available on the [[http://www.keil.com/uvision|uVision homepage]].
+  - **Install StellarisWare** \\ It's path on CD is //Software/SW-LM3S-5570.exe//. It can also be downloaded from Texas Instruments Stellaris [[http://www.luminarymicro.com/products/software.html|web page]]. It is necessary to install the software to the "C:\StellarisWare" folder otherwise example project files should be re-configured.
+  - **Copy examples to your computer** \\ Copy Examples folder from CD or from web-page to any place in your harddrive. Please note that after modifing project files, uVision saves file paths as absolute so moving the folder later can cause trouble.
+  - **Connect the programmer to your computer** \\ Stellaris Evalution Board clone should be found. Install the device drivers located in //Software/Luminary_FTDI_Driver// folder on CD or download them from the same site as StellarisWare.
+===== Run test =====
+[{{:images:hardware:arm-can:install:uvision_demo_project.png|RGB LED demo project opened with Keil uVision}}]
+~~CL~~
+Try any of the example projects with Keil uVision. For example, locate "rgb_led_demo" project and open "rgb_led_demo.uvproj" file. You can use uVision to compile and download project code to an ARM device - there are quickbuttons on the left side of the toolbar for this. Please note that uVision does not reset the device after programming so it is required to press the reset button on the Controller board (the left one) after downloading the code.

en/hardware/arm-can/setup.1274890428.txt.gz · Last modified: 2020/07/20 09:00 (external edit)